308-06 Manual Transmission External Controls 2013 - 2014 Fusion
Removal and Installation Procedure revision date: 04/24/2013

Gearshift Lever

Removal

    1. Apply the parking brake.
  1. On both sides
  1. On both sides
  1. On both sides

Installation

  1. Torque : 9 Nm
  1. Torque : 8 Nm
  1. Torque : 9 Nm
  1. On both sides
    Torque : 8 Nm
  1. Torque : 9 Nm
  1. On both sides
  1. On both sides
  1. Adjust the gearshift cable when a new selector lever is installed.
    Refer to: Gearshift Cable Adjustment (308-06 Manual Transmission External Controls, General Procedures).
    1. Release the parking brake.

  1. NOTE: Anytime the parking brake switch electrical connector has been disconnected, the EPB system is deactivated and a DTC is stored in the ABS module. Perform the following step to restore the EPB system and clear the ABS module DTC .

    Apply and release the parking brake twice, pausing with the switch in the NEUTRAL (AT REST) position between apply and release.


Copyright © Ford Motor Company